I have gathered my first set of data and created a few plots.  The first plot that I experimented with is the output flux (in electron) and the input line flux (in ergs/sec/cm^2):

The next plot is detected x-value versus input x-value:

The following plot is detected y-value versus input y-value, notice that this one is very similar to the previous plot because the detection parameters for both the x and y values are the same in the detection algorithm:

This final plot is detected z (redshift) versus input z:

Notice that this final plot has a much thinner line than the previous two.  This is due to the fact we only accept an x or y value that is within plus or minus 0.25 arcseconds, and we only accept redshift (z) values that are within plus or minus 0.01 arcseconds.  More plots should come up in the following week with more intuitive and helpful data.